Posted by Leroy on February 28, 2019 at 04:10:15 from (96.45.243.241):
In Reply to: Re: Old John Deere posted by MT RON on February 27, 2019 at 22:17:58:
No problem with the hand clutch, it is not used in the operation. You park it dext to the manure pile like from a straw pile from the thrasher that the cattle would tear the pile apart over the winter just like if you were going to use a back hoe. But instead of a back hoe the arm bending and the bucket going over what you want to pick up the bucket slides out along the arm and just pushes into the pile. You park the outfit as close to the pile as you can and get the spreader in reach same as if you were loading from a back hoe. and tractor stays put in one position untill the manure is all picked up within reach of the loader and then you move to a different spot on the pile. Same way with the steam shovel that pushed the bucket into the pile of dirt. You do not use it in the barn but just outside. Think about in modern times where you put a round bale out for them to feed on and a lot of the hay will get pulled out of the bale and tramped into the manure pack the bale is sitting on and place a bale exactly the same every day that tramped in pile of manure just keeps growimg bigger all the time. They would work good in that situation now. Would work same as a back hoe with a reversed bucket. Instead of the back hoe arm bending to move the bucket thr bucket slides along a stif one piece arm instead of the 2 piece arm of the back hoe.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.