Posted by Mike M on February 28, 2019 at 05:16:45 from (24.140.3.210):
In Reply to: Old John Deere posted by SVcummins on February 27, 2019 at 19:27:27:
I'm the fellow in Ohio with one that Leroy talked about. Years ago he was kind enough to make a copy of some original literature and stopped in to see me and the # 26 loader. I also have an original owners manual and they are really a nice manual. They also made a dirt bucket for them. Before my time my uncle wore one of these out using it to load out trucks in a gravel pit. When I was a kid I remember seeing some parts of it laying around. I think they were going to use some of the parts to make up a sawmill but never did. There was one of those tined buckets turned upside down in the yard. IIRC the dog they had would climb up on it as it was in his area he could reach from his chain. I found mine not too far up the road from where I live. It was sitting close to the road and all grown up around it. I rescued it and got it operational. I even found a factory defect in it when I went to mount it on my B model JD. It had spent it's life on an A model. There are 2 sets of holes in the mounting brackets. The ones for the B on the one side was not drilled in the proper spot and needed reworked. LOL.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.