|
Tractor Talk Discussion Board |
Re: What a puller!!! My 806 is a beast
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Jimmy on October 03, 2001 at 04:22:38 from (216.40.218.223):
In Reply to: What a puller!!! My 806 is a beast posted by Red Power!!!!!! on October 01, 2001 at 08:43:57:
Sounds like feelings were hurt in this exchange, I have to agree that the black dirt is tough stuff. I farm cotton in North Texas and find that I have to adjust from field to field, some of our land is sand and some black dirt and the same tractor that would pull 5 bottom in sand WIll NOT pull 5 bottoms in blackland without breaking a plow or a just plain hanging in the stiff dirt. Same goes for a disk plow, have to adjust for dirt. This really isn't time to plow anyway, the soil has very little moisture in it. You have to catch it just right, too little moisture and it will come up in chunks, too much and it will just ball up and stick to the plow making a nice mess. Best bet is wait till a good rain, let the ground start to crust over, then try it. Think of our poor forefathers, my GF included, who worked this rotten blackland with Mules and one bottom plows. Those guys were REAL MEN....and we argue about tractors!
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
