Posted by rustred on March 19, 2019 at 18:34:43 from (108.173.59.31):
In Reply to: Re: W9 McCormick posted by RedMF40 on March 19, 2019 at 08:26:28:
the story is that an old guy bought it new. he passed away and his neighbour was farming his land and bought it. tractor was sitting in a shed there. they moved it to their place . then he got a kid to pull the head off cause they thought it was seized. the kid never did finish the job. and in the mean time this tractor sat in their shop for eighteen years. then he thought he better sell it. I bought it and brought it home. finished the job. removed rad and flushed the mice, canola seed and mouse nests out. flushed the block was full of peas and canola. removed fuel tank and pressure washed it inside. was full of old rotten gas varnish and scale. made new battery cables 2/0 yes put in new 6 volt battery, set the valves, checked the spark,set the timing adjusted carb, oiled the cylinders, cranked it over about 10 times and away it went. ooh ya then shut her down and fix carb to governor tang, was not in place. then tried it again fired right up with 2 revolutions. warmed it up and then retorqued the head and set the valves. adjust carb again . then went for the first drive in the snow. and put a muffler on it. starts with 1/2 revolution now. I looked in spark plug holes and can see high dome pistons in it. so someone did an overhaul at one time. its about as original as it gets. it has about 17 years of work on a 69 year old tractor. so im happy with that.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.