|
Tractor Talk Discussion Board |
Re: Goin' outta business sale (least in the S.E)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by keith TX on October 13, 2001 at 03:40:10 from (216.40.218.77):
In Reply to: Goin' outta business sale (least in the S.E) posted by ShepFL on October 12, 2001 at 17:07:12:
Remedy is an EXCELLENT herbicide. When I bought my place in Texas is was covered with the dreaded mesquite trees. Some were 8 inches in diameter. I would estimate there were 500-600 of these on the original 24 acres I bought. I used remedy mixed with diesel fuel at a rate of 1/2 cup remedy per gallon of diesel in a Solo backpack sprayer. You can mix it with water but most old timers recommend the diesel because it sticks better and you can tell for days which tree you have sprayed. When spraying in hundreds of trees, it is easy to lose track of which you have and havent sprayed. Spray the trunk of the tree at ground level and spray all the way around the base of the trunk. Do not worry about the leaves. Just a 6 inch band or so all the way around the trunk. I got nearly a 100% kill. Then after a year, I had the unpleasant task of cutting these down, dragging and burning them. This had to be done almost by hand and foot because mesquite trees have very sharp thorns that make tractor work around them impossible unless you just enjoy fixing flats. The mesquite tree is a very hearty plant, I would compare it to the locust in the Eastern US. I would think it would kill the trees you mentioned quite easily. Email me if you have any questions, I will be glad to tell you what little I know! Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
