Nebraska had a category 2 hurricane go over, with a bad blizzard in the west and a bad 2 day rainstorm on the east. The east had a tougher winter than normal with a lot of snow and very deep frost for them.
All the rain and all the snow melt came loose in 48 hours and flowed over the frozen ground. The creeks and ditches and rivers were full of ice and no room to flow water.
Now the west side is melting out, so the water keeps flowing. It affects some of South Dakota and Iowa and on down the Mississippi River.
The snow pack is now melting out of North DAkota and west, and all that water is coming down to add on to the high water levels.
That deal was a disaster bigger than many of the hurricanes hitting the Gulf of Mexico and any hitting the east coast. But, it’s just fly over land, so no one covers it, it’s not news if it doesn’t happen on the east or west coast.
Anyhow whatever, I feel for all those people, they had at least 81 bridges washed out, dams failed, rivers changed course, many miles of county and township roads undercut and destroyed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
