Posted by RBoots on April 08, 2019 at 19:19:58 from (173.241.113.101):
In Reply to: What a mess posted by 37chief on April 08, 2019 at 17:14:59:
Stan, I feel for ya. I'll just get a road all scraped/shaped perfect, then some jackwagon will do donuts in the intersection, or just stop randomly and lay a set of deep posi tracks in it. However, when I come back to scrape it the next time, I leave that stuff there, let every person that travels that road drive over it. Maybe if someone knows the person doing it, they'll tell them to knock it off. Now if I see the person do it, I'll make note of who it was (after you work in the same area long enough you know who is who and what vehicle goes with each house), and if I see them do it, I'll go gouge a lip along the end of their driveway, give them something to think about for a few days before I go back and fix it. Sometimes once is all that it takes for them to figure out that I'm watching. If it ticks them off and they go at it even worse tearing things up, I'll put a real good gouge along the end of their driveway and then scrape a 4" or so bank of gravel in front of it. It doesn't take long for that to get real old and they'll usually knock it off after I fix it the second time. Usually the people that do that kind of crap around here is either teenage boys trying to show off to a girl that could care less, or white trash that is govt raised that is home all day with nothing better to do.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
