I would put concrete in the bottom of the hole to support the load. Just dumping some sackcrete in may work in some places but not in my area that we get deep frost. The frost will move the post up and down. I have one shed that is raising out of the ground. I have had two different shed additions that where added to the sides of existing barns that sunk over the years. In the last ten years, we have jacked them up and put concrete columns under them. We go six foot deep to make sure and get below the most common frost line.
As for trapping water with just a plug poured and the post setting on it. I do not think that there would be much water held just by the post setting on top of a poured concrete plug.
Also spend the money to get the properly treated posts. The cheap ones at the box stores do not have enough treatment to last very long in direct ground contact. Also watch the post that many of the Amish sell in barn "kits" they many times are based only on price, so you get cheaply treated post.
Think of this. Pouring concrete plugs under the posts might cost you $100-200. Now spread this over the usable life of the barn. Then think about the time/trouble you could easily have IF your post sink. Too many time when we cut corners we shoot yourselves in the foot for little gain.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
