Well, I've learned a bit in the past few weeks and have come up with the following plan. I think since this tractor has power steering, and since I'm willing to give that up, it'll be remarkably easy to hook this implement up.
The implement itself needs the following: A hydraulic pressure line, a hydraulic return, and a very unrestricted "case drain" line used by the hydraulic motors on the implement. The previous owner of the implement simply plumbed this "case drain" to the oil fill cap on his reservoir.
Since the implement is "open center", (it always has hydraulic fluid flowing even when the individual functions are off) and since the implement has it's own electronic switches for the hydraulic functions, it would appear I do not need to add the (difficult to source) SCV to my Deere 1050.
The tractor has power steering which I will disable. The power steering had a pressure and a return delivered to the steering valve by a "Flow Divider Block".
I will simply disconnect the power steering hoses from this flow divider block, thread in quick-disconnect fittings to the pressure + return of this flow divider block (where the power steering was previously connected) and attach my implement there.
I'll also conjure up another return for the "case drain" to dump directly into the reservoir via the fill cap.
When the implement is disconnected from the tractor, I'll put a loopback hose in it's place to dump the pressure oil thats coming out of the flow divider block straight back into it's return.
Curious if anyone sees any problems with this plan!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
