Posted by Bunchgrass Farm on April 23, 2019 at 18:29:52 from (64.126.171.8):
In Reply to: Re: Shop Question posted by showcrop on April 22, 2019 at 15:20:08:
Standing seam usually requires an installer -no? Or can you rent to seam crimper tool etc? That roof can get pretty pricey when you have it installed by someone else.
Almost every barn/shop builder here uses the standard 29 ga metal and screw it to the purlins ---- and, almost guarantee some half hits and misses when they're flying blind due to the vapor barrier occluding their vision of the 1.5 in wide purlin. Guess that's where we get the leaks, eh?
One tip I was given regarding attaching the tin w/ screws was to stack a pile of similar lengths together (say wall metal), mark the screw positions w/ a punch(every 2 ft if that's purlin spacing) and then predrill the holes (through 8 sheets or so at a time). Shooting the screws goes so much easier when you're not trying to start a hole in the metal with a screw AND it allows you to fine tune the metal positioning because you're not monkeying with the screws so much.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's The "Stuckest" You've Ever Been? - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I was about 14 (part of the problem) when I got stuck. I was disking with a cab equipped IH 966. The window was dirty and I was driving into the evening sun. It was hard to see and it was my first pass down the field. I got the tractor so stuck that the underside of the tractor was resting on the ground. My uncle wanted
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
