Posted by 2wheelgnnr on May 06, 2019 at 09:07:03 from (104.229.212.4):
Have a Jube...and had to dig some post holes this weekend for a fence. borrow one from a freind...got it loaded on and found 3 point did not raise it tall enough to have auger straight up and down.....whatever...found a way to get it all done dug holes just fine...but then after I was done later that evening hit me!!
the hole time I had it in draft control. I think and am guessing the hole unit/3 pt woulda raised a bit higher if it was NOT IN DRAFT mode..
I think this was my problem as I was used to my 3 pt on my 8n lifting the implements higher but. I think I learned my lesson.
It was in draft mode since I brought her home 2 years ago but this was the first time I really used her. I feel like a rookie!!!
Im thinking I would have had more movement in the lift if I did Have in draft mode. oh well...holes dug and the usual rock magnet auger....did not find ANY so all is good!!!!!!
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
