Posted by rrlund on May 14, 2019 at 05:42:16 from (69.36.62.180):
In Reply to: Re: Roundup? posted by tomstractorsandtoys on May 14, 2019 at 04:07:22:
Like I said in another reply,there's always Liberty. As far as restricting everything,I'd be OK with that. It's that time of year when,if you pay attention,these forums are going to be loaded up with people asking sprayer questions. If they were certified,or even had the book,they wouldn't have to ask. If you have to ask,or use this stuff hap hazard without knowing what you're doing,you flat out shouldn't be using any of it in the first place. Joe homeowner isn't going to spend weeks studying that manual and taking half a day off to take the test every three years just to buy a quart of ready to use glyphosate once a year. I'd rather eat bees than take that thing,but I have to.
As far as going back to cultivating,you and I both know it can't happen with no til or minimum till. Too much trash.
I don't know how these judgements can ever stand up under appeal anyway. No science to back it up. It's all just based on emotion among jury members. Even the EPA has come out stressing that it's not carcinogenic.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
