Posted by paul on May 14, 2019 at 09:14:41 from (76.77.197.114):
In Reply to: Re: Roundup? posted by Traditional Farmer on May 14, 2019 at 07:49:05:
I appreciate we can have different opinions. I often find your comments very puzzling, but it’s all good. It gives an opportunity to continue educating.
Supplying good food is what it’s all about, and that’s what I do. Most of my grains go to feed livestock or to exports, but a small percent likely finds its way into non-animal foods.
Can’t help what General Mills or Heinz-Kraft or the rest do to the raw ingredients I supply them. But that is where 90% of the issues are. And I do t even blame those companies, they were producing what people wanted. Cheap, fatty, salty, sugary. The basic food drugs.......
People finally got tired of the poor quality foods but didn’t know where to turn, good of them to at least see the issues. Don’t blame them a bit for wanting a change.
Now to get them educated to turn in the right directions, and ignore the chattering internet bullies.
We are getting there. It doesn’t happen over night.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
