Posted by rossow (mn) on May 21, 2019 at 12:56:56 from (69.24.180.147):
In Reply to: Re: gas! posted by rossow (mn) on May 21, 2019 at 12:00:22:
Reply to my own post: After reading this thread, I thought, what the heck, so I dragged out my tiny old Remington 14-inch saw from the 1970s. I had given up on it ever running again back in the early 1980s, and it has sat in my machine shed, unused, for more than 30 years. So, with nothing to lose but a pint of fuel, I put a non-ethanol 2-stroke mix in it and let it sit for a couple of hours. I wouldn't believe it if I hadn't seen it, but it started up on about the third pull, killed, then restarted on the first pull and ran well at idle and higher speed. Was it because of the 91 non-ethanol? Would 87 ethanol have achieved the same result? Chainsaw gods at work? Simply had a good three-decade rest? I don't know and don't care, but now it runs, to my utter amazement.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
