|
Tractor Talk Discussion Board |
Power steering for Farmall Super M.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Glenn Thoming on June 12, 2007 at 07:03:35 from (67.43.252.51):
I’m planning to install a Char-Lynn steering valve on my Farmall Super M. Model SM, Serial # F-32828-J.
The M has a bucket on the front and an aftermarket 3-point hitch on the rear. They both work at the same time and the hitch is power-down too. My problem is that I’m not sure how to connect the steering torque generator into the hydraulic system. There are no hoses connected to the left side of the engine. Those two points have the small round plates covering the openings. It has been suggested that the motor be connected in series with the loader control valve. The steering valve is “open center” but would it restrict the flow to the loader too much. This is my first venture into hydraulics.
Replies:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
