There is a huge pile of those mill drills sitting in shops and garages collecting rust and dust and there is a reaon for it. Personally you couldn't give me one if I had to use it to make parts. Am a machine tool snob? Maybe but taking half a day to do an hour job and getting it close but not right does not suit my personality.
Three reasons not to own one, maybe 4, or maybe 5. Number 1- the primary issue I have with them is the reason I own a mill which is to make flat cuts on a work piece and end up AT A GIVEN SIZE measured in .001 increments. There no way to do this on a mill drill unless you add scales to it on the quill and good luck. After you add the scale and spend forever getting it set where you want it make a cut and report back how close you got it. Number 2- by the time you add a chuck and vise there isn,t enough distance between the quill and table to use it for anything but smallish parts. Number 3 it is very likely a step pulley drive, wouldn't have one in the shop unless it was converted to VFD,, more $$ to spend. Number 4, not enough table movement to work on anything but small parts. Number 5 they take up space in the shop while rusting away until you find a buyer. I WISH that somebody had made these points to me in a direct manner before I made the mistake of buying one. I now own a 9x49 knee mill.
Bottom line is a mill drill is OK if you are building models or working on parts that are the size of an egg cartom AND you have lots of time and patience, otherwise get knee mill, lots of them for sale used and new.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.