Posted by Steve@Advance on June 29, 2019 at 18:28:44 from (66.169.147.211):
In Reply to: SC nonstarting posted by Roaddevil49 on June 29, 2019 at 16:48:35:
The missing plug in the bottom of the air in of the carb is supposed to be a sintered bronze plug. It's purpose is to let excess fuel to drain out, and to prevent dirt from entering. It is not essential to run, not sure where you would find one, maybe in a master rebuild kit or rob one from an old carb.
The dripping fuel following a failed start is completely normal for an updraft carb. When the engine fails to start, any fuel on it's way up the intake comes draining back down once the vacuum stops. Your mixture adjustments are close enough for an initial start.
I think you have an ignition problem, points out of adjustment, firing order wrong, carbon tracked/wet cap, weak coil. Do you hear the impulse mechanism clacking when cranking the engine?
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.