Posted by tomturkey on June 29, 2019 at 20:59:17 from (66.211.9.225):
In Reply to: SC nonstarting posted by Roaddevil49 on June 29, 2019 at 16:48:35:
I'm a old guy novice so not very smart so my thoughts maybe way off base. Pull a plug wire, crank it over, as soon as you see the spark stop cranking. Trace the wire back to the cap and and now you will know the next wire to have spark. Check the cylinder that wire leads to, to see if it is coming up on compression, if it is not find the cylinder that is. That is where the next firing wire needs to go. Then you follow the firing order to check your wire. Ofcourse the normal way would be to take off the cap and and watch the rotor and send that wire to the cylinder coming up on compression. I believe you are not firing on the compression stroke. Wires all in wrong place. The rotor does not care which post is number one, its going to send spark to each wire in rotation, the spark must go to the cylinder on its compression stroke. But I am sure you know all this. Wishing you the best on your project. Remember anytime spent with your tractor is quality time. gobble
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
