Used to be a metal detector enthusiast. So many times I've seen someone who'd take a perfectly good machine, not find anything, then call the machine junk.
First, the machine needs to be adjusted properly. I don't have experience with the hand wands, but I'd assume there is a sensitivity adjustment. If looking for nails in wood, then you'd want max sensitivity and, if an option, in all-metals mode.
Next, the user needs to move the detector at a speed that allows it to 1) pick up a signal, 2) process that signal, 3) give you the results. Move the detector too fast and no matter how perfectly it's set, it'll miss any targets. Also, some machines process signals faster than others.
And finally is the skill and patience of the operator. Read the directions, practice with small nails under varying layers of boards (both wet and dry, cause it'll make a difference), and "learn" your machine. Practice not only scanning the broadside of the nail(s), but also at varying angles and from the end of the nail.
There are detectors out there that cost thousands of dollars, but in the end, they ALL work the same. I have a Tesoro Silver uMax. No display; only a single tone, but is amazing how much information that tone can supply if you understand its language.
If all you're looking for are nails, you can use most any detector. If your target (nails) will be in no more than 6" of wood thickness, then most any should work. Look to see what the manufacturer's specs are, then take into consideration that those specs are best-case scenario, by folks who know the machine.
Again, have never used a hand wand, but pretty sure there are some that work better than others.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.