Tractor Talk Discussion Board |
Re: Re: Re: What will be the worst tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Nolan on December 04, 2001 at 04:39:40 from (209.48.190.220):
In Reply to: Re: Re: What will be the worst tractor posted by Bill from up north on December 03, 2001 at 21:39:29:
If the tractor part was no longer serviced or available aftermarket, you would find parts the same way many of us do our older cars right now. Scrounging at junk yards, swap meets, e-bay, etc. The web has made it much easier, giving global contacts with ease. Not only can you search the world for parts, but you can search the world for knowledge. As for the many cars that have been junked because of a bad brain box, that's usually just a flat rate mechanics determination to beat the clock. Many times, with just a little investigation, one can find the individual diode or such that needs replacement on the board, if the board is bad in fact (many of them have a lose wiring connection or ground actually). As for repairing brain boxes I know of shops that specialize in this sort of board/box repair work. They do nothing but repair circuit boards and computer boxes for various equipment and vehicles. Computer boards and such are only intimidating to those of us who don't know our way around them. To these guys, it's as basic as a lawnmower engine, and just as repairable. But again, in this country with it's "new and improved" throw it away because it's old mentality, many easily repairable items are thrown away and replaced with a new one because the owner does not want it repaired. That includes tractors and automobiles. Not that they can't be repaired, not that it can't be repaired quite affordably, but simply because the owner doesn't want it repaired.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|