Posted by JD Seller on July 04, 2019 at 07:06:29 from (208.126.198.213):
In Reply to: Grease Fittings posted by fbh44 on July 04, 2019 at 04:45:49:
It all depends on the size of your drive in fitting. The most common is close to the same size as the 1/4-28 screw in fittings. So you can often take a 1/4-18 tap and thread the hole for a screw in type. The larger common grease fitting size is 1/8 pipe thread. This is in SAE fittings I do have an assortment of metric fittings that can be used too.
I will second hating the drive in fittings. IF you have one that become obstructed and the grease gun tip locks on under pressure, you just about always loosen the fitting getting the gun off.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Central Illinois Strawberry Festival - by Cindy Ladage and Janna Seiz. Every year the coming of summer is highlighted by different events for different people. For some, it is heralded with the end of school, tilling the garden, or completion of the planting season. To us, connoisseurs of find food, antique tractors, farm toys, crafts, and downright fun, the annual Strawberry Festival means summer is here. Every year, in Carlinville, Illinois, the Macoupin County Historical Society and the Macoupin Agricultural Antique Association team up to fill th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.