Posted by Janicholson on July 07, 2019 at 06:44:41 from (199.17.6.141):
In Reply to: slag posted by randy1 on July 07, 2019 at 02:57:44:
I am a slag understander. Slag is the limestone and silicate residual material from the blast furnace smelting process of Iron or into pig iron. (also the weld cover on SMAW welds, but not being discussed) The slag is tapped into thermal gondola cars and dumped, cooled, and crushed. It contains multiple gaseous bubbles and inclusions. It is hard in places and bubbly soft in others. When crushed to 3/4", and the fines are left in it, it becomes a good road base. It will wear out in 8 to 10 years of driving on it, and needs periodic shaping to keep a crown, but as it breaks down, the fines create a solid non washing foundation. New layers on top get a bit squirrely at first unless they have substantial fines. It will soon settle down. When first applied, it may have a sulpherous smell. It is cheap. Works, and says put when settled in. Jim
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
