Posted by jimb2 on July 23, 2019 at 11:38:23 from (174.114.155.238):
In Reply to: More baler questions posted by Grandpa love on July 23, 2019 at 11:07:24:
Hi Grandpa, we had one for about 10 years or so. Traded up from a worn out IH #46 to #47. I didn't like the #47 as well as #46 as the #47 had a short pole and the one piece PTO so you couldn't turn as sharp on the corners. The knotters had the usual early IH knotter problems, keep the twine knife sharp, sensitive to quality of twine, no thick and thin spots and clean all the hay chaff and twine bits out of the knotter everyday or every time you add a ball of twine. On ours the outside knotter liked plastic twine and the inside liked sisal twine. My brother traded it in on an IH #430 with "All Twine" knotters and they rarely missed a bale on either sisal or plastic. A neighbor retired from farming and my brother bought his IH #435 "All Twine" baler that has a wider pickup and more capacity than the #430.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
