Posted by dhermesc on July 23, 2019 at 13:04:03 from (24.248.193.103):
In Reply to: More baler questions posted by Grandpa love on July 23, 2019 at 11:07:24:
At this stage of the game it about has to work or else it would have been parked outside rusting away. Lots of salvage balers out there to strip parts off of.
If it has the "all twine" knotters retrofitted on the baler its probably pretty good. The original knotters on those balers were not very good and could drive a person to drink if they decided not to work. If the old man had bales of hay on the farm most likely they came from this baler. I have a 47 wire tie baler - it is not near the capacity of the 276 New Holland that replaced it in the starting lineup. The early 440 balers were similar to the 47 in capacity - the later 440 balers and 445 balers would be similar to the 276 New Hollands.
If it can make a bale and tie it that baler would be cheap for NE Kansas even as rough looking as it is. I watched a 46 baler that had been used the summer before (it worked) bring a $1200 at auction. I sold a 46 baler that would only tie on one side (guaranteed) and the guy gave me $200 cash and a cheap handgun for it (Bersa .40 cal).
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.