Take a look at the CUTTER BAR, REGULAR diagram below.
Note the rock guard(Key 36), ledger plate rivet(Key 37), and guard ledger plate(Key 38).
Take a look at your photo below.
Notice two ledger plates are missing.
Inspect every rock guard on the cutter bar.
If a ledger plate is missing, then either replace the rock guard or install a new ledger plate.
Take a look at the CUTTER BAR, REGULAR diagram below.
Note the outer shoe ledger plate(Key 41).
Inspect the the outer shoe and replace the ledger plate if necessary.
"I do have an operators manual"
Review your operator's manual section on how to register the knife.
Since the operator's manual was published between 1936 and 1956, the instructions may vary from one manual to another; however, the basic, fundamental method is still the same.
Review your operator's manual section on the alignment or lead of the cutter bar.
Review your operator's manual section on the knife hold-down clips and wear plates.
Review your operator's manual section on the cutter bar tilt adjustment.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.