Posted by Mike M on July 26, 2019 at 07:02:16 from (24.140.3.210):
In Reply to: OT- Mitsubishi? posted by Bret4207 on July 26, 2019 at 06:22:37:
Your Escape likely had the same rust out warranty. How much good did that do for you ? Guy at work had a small car made by Mitsubishi. He got really good life and service from it. It was just getting really old so he traded it off on a Jeep Renegade. I was surprised he did not get an Outlander not sure why but he did mention the Jeep dealer was offering $ 5,000 trade in on anything so I think that hooked him ! lol. The other guy mentioned to older dodge truck. But Dodge had some other cars and engines from Mitsubishi that did not have as good of reputation ? but that was many years ago and things change a lot. If you have a dealer near by and check out an extended factory warranty I don't see how it would be much different than any other brand ? I can tell you stories of dud Honda's , Subaru's, Toyota's and even way more Ford's and dodges and even more yet GM products ! Myself we have been getting good service out of our Honda's so far.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
