Posted by Joel Sanderson on July 31, 2019 at 15:12:37 from (204.106.240.102):
In Reply to: Horses hay acreage posted by Pete in Holland MI on July 31, 2019 at 12:57:03:
Horses vary hugely between breeds. My arabian hardly eats any hay, while I had a haflinger that chewed through a round bale in two days! We'd left it in the lot for when we were on vacation. (Whoops.) My arabian, which is my road horse, barely eats two slabs of hay a day--and that has to be pure alfalfa or he won't touch it at all. The haflinger is from a northern climate and was bred for filling up on grass, so they have big stomaches to fuel them all day long as it digests. Same with other work horses. The arabian was bred in a desert where there is no grass to fill up big stomaches, so they eat richer food like dates, figs and alfalfa. I've even heard of feeding them dried meat! My arab eats grain, beat pulp, wheat sprouts, oatmeal and anything but grass. It has to be rich food, because he's lean. So that breed won't chew through a haymow like a workhorse will.
You can expect two bales a day stuffed into a workhorse. If you're feeding 50 pound bales and your hayfield's making 4 tons an acre, that's about 2.3 acres to feed one horse. A team of six would be almost fourteen acres. Add in the grain, and on a 40 acre farm, you're looking at close to half your land just to feed your hungry helpers. On the other hand, if you have waste ground that can't be tilled but can be pastured effectively, horse power is more economical.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
