Posted by andy r on August 01, 2019 at 16:58:06 from (208.126.193.44):
I have an older but good functioning septic tank that is beginning to be overtaken by roots from a Maple tree. The septic tank is still outside of the drip line of the tree. The tree provides valuable shade and is a good wind break for the house. I really do not want to take it down. I am thinking of cutting a trench between the septic tank and tree to: 1) at least kill the roots that are presently growing around the septic tank and, 2) set the roots back a few years before they can grow back to the septic tank. I probably could get 20 feet back from the septic tank and still be 20 feet away from the trunk of the tree. A contractor said I could throw some softener salt in the trench as it was back filled to help hold the roots back as well. I have even wondered about placing some 1/8 inch poly in the trench as a barrier to slow down the roots. Poly comes in 4' by 8' sheets from Menards. Can the tree survive this?? Can I slow down the roots? I know I dug in some electric wires 3' to 4' deep, 6 feet away from another Maple and it didn't phase it. Any ideas greatly appreciated.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
