Posted by leroy in ne on August 02, 2019 at 17:48:36 from (71.29.209.39):
In Reply to: Did the baler work? posted by gotmyfarm! on August 02, 2019 at 14:22:47:
Spent very little time around a 14T but remember 540 pto speed is necessary when baling , don't idle down tractor and make sure it is running that speed when baling not just running empty baler, no rust on knotter parts. I watched a man with abrasive cloth and penetrating oil spend 1/2 a day cleaning one that he bought out of a fence row that was parked when a big round was purchased by farmer, much cleaning and a few minor adjustments before it tied right. If I remember right these take a special bolt for the shear bolt in the fly wheel. They look like a 1/4 inch bolt but are like 9/32 thru shank portion and machined down for 1/4 inch nut and made of a special alloy, I suggest getting several from mother Deere. My memories only, no warrantee on my statements
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.