If you are at the mackinaw bridge the 5th September they will have the tractor drive going. Around a 1000 tractors that day. Will cross the Mackinaw bridge. There is some iron tourist deals west of Duluth. If you come back from Glacier by way of ID stop in at Grangeville ask if Ted is still around at the deere dealer to see his collection of tractors. 2 Pols barns full of everything you can imagine about from old Rumley or such to Cat tractors and one building must be about 60x80 or more. concrete floor in one the tracks are on stone floor. I saw them about 5-7years ago and he was in his 80's then. The trip down either ID 55 or US-95 is worth the scenery through there. From McCammon ID to Little America US-30 is a nice drive with a lot of looking across there. Another nice drive is from Idaho Falls to Three Forks MT up US-20 to 287 either one from West Yellowstone Looking on a map you will see what I mean. Wy Cody has the Cody museum there, and Mt in Great Falls the Charles M. Russell Museum. Billings will be having the State fair along in here some time close just before or just after you are through there. Some intersting things along US 212 from Broadus MT to Crow Agency MT along with the Custer Battle field just outside Crow Agency MT. I would not plant to drive 212 across there at night though. West of Broadus. Bell Fourche SD is interesting to go through. Not been there in a few years so not sure how much is left to see. Used to be a nice little old cow town.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
