Tractor Talk Discussion Board |
Re: Tube or tubeless tires - is one better?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by A. D. on December 19, 2001 at 19:38:43 from (216.218.84.169):
In Reply to: Tube or tubeless tires - is one better? posted by JAE-Tx on December 19, 2001 at 13:20:20:
Radil tires offer more traction than older style bias ply tires, this is a proven fact. I am a tire dealer by profession and an old tractor nut by choice.In my experience radial tires may be easier to snag or rip a hole in the sidewall if a sharp object hits the sidewall because the radial plies ( all of them) run at a 90 degree angle to the rim( radially). Bias tires on the other hand have plies that cross over each other at an angles (60 degrees). The radial tires have a slightly more bulge when they contact the ground and they have more flex. The bias tires on the other hand are much stiffer in the sidewall. Radial tires are Much more efficient. I do not sell tractor tires but I would always suggest to run tubeless if possible. A tubeless tire is nothing more than a tire with a air proof liner made on the inside of the tire. The basic tire constuction is the same for tube type or tubeless tires except for this inner liner. Your wheels must be compatable with tubeless tires ( no leaks). With a tube that gets punctured you get a flat quicker because air can escape from the wound area and around the valve stem hole. On a tubeless tire you sometimes get only a slow leak around the puncture if the object stays in the tire because air will not escape from the valve stem. You can get by for a while just adding auir until you can get it fixed. DO NOT remove the object or it will go down. The object acts as a plug. I can not answer about liquid inside tractor tires with any authority because I do not sell them. I do know from passenger tire experience that almost all liquids (fix a flat, etc) in time will cause a mess with the wheel. I would probably suggest that you get radials if it is a work tractor. If you run them dry go tubeless. If you fill them use tubes. There is NO right or wrong. Both have advantages in certain areas. If it were mine I would go dry tubeless and add weights if needed.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|