Posted by gotmyfarm! on August 13, 2019 at 12:43:06 from (184.100.69.20):
In Reply to: Guess what happened posted by gotmyfarm! on August 12, 2019 at 17:08:09:
[quote="RedMF40"
If I felt qualified, I might advertise to fix balers. I only fixed one so far and have never even seen another baler up close and what differences there may be. I would guess they are all very similar, those old balers, all makes and models. I would need more experience to feel like I could confidently go to any baler and be able to fix it right away.
No major work on this one today. He was just missing (somehow got broken off) the trip dog lever and he didn't know where it broke from and how to trip the baler without it. I showed him how to trip it without the lever and where the lever used to be. He knows how to weld so is a really easy fix to weld on a tiny lever. It was fun to meet a nice neighbor for a change and see his cows AND the best (or worst) part is he told me who the other neighbor over there is that has Brown Swiss cows and said he'd probably be happy to show them to me. Wellllll, the old guy offered to GIVE ME a month old brown swiss male cow. Says I can think it over and let him know this weekend. I didn't want a boy cow, just maybe a couple girls, but he is so so so cute. I'm not really mentally ready for another large animal but it is so tempting. Really nice herd, too, that he comes from. Swiss are hard to find. hmmm
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
