Posted by keith True on August 16, 2019 at 07:47:45 from (73.68.29.112):
In Reply to: Black Blast---NO posted by big tee on August 15, 2019 at 19:08:20:
I've used hundreds of tons of coal slag.Black Beauty,Black Blast,Patriot blast,different names but all coal slag.There are different grades of it,a lot of times what stores carry won't go through some peoples blasters.I've blasted lots of tractors,cranes,dozers,backhoes,and probably a couple hundred dump bodies.For equipment like that I have to use what they call fine grade.I never blasted anything where I could use what they called medium.I believe the bridge crews use that grade a lot,at least around here.Coal slag,(NOT coal dust)has a low free silica content.Almost zero,the warning labels on the rap sheets say treat as a nuisance dust.I always bought it at the power plant,there are plants set up at the coal plants that crush,screen,dry and bag the stuff.It comes 3000 pounds to the pallet.Coal slag is hard,and actually cuts when it hits.On sheet metal it can make a little cut and leave a little flap,and painting over it will bridge it with a little trapped air under it.That is all in a microscopic setting,and I personally don't think it amounts to anything in real life.Silica hits,and explodes sideways,cleaning off paint,rest,and leaving the surface pretty much untouched.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.