Posted by gotmyfarm! on August 16, 2019 at 16:35:36 from (184.100.69.20):
In Reply to: SOS posted by gotmyfarm! on August 14, 2019 at 11:49:59:
No, don't have a pool!
I know right where it's clogged. Along, straight pipe about 15+' long under the kitchen floor, in the basement ceiling. I've had the pipes under the sink taken apart for days and have been pouring vinegar and sometimes baking soda and boiling water and "plunging" it with a turkey baster, hoping it would dissolve a little and break loose. No, isn't loose. I can feel right where it is if I pour hot water in the pipe and go in basement and feel where the pipe suddenly gets cold. I was putting off buying a snake because how often do you need a pipe snake, like hardly ever, so I hate to have one lying around in the way. I think I'll cut the pipe and put a clean out spot in there since it's so long of a pipe. Probably won't need the snake then, if I cut right after the blockage.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
