Posted by dhermesc on August 25, 2019 at 06:23:32 from (24.248.193.103):
In Reply to: Got a baler posted by Grandpa love on August 23, 2019 at 18:21:49:
I would pull the old hay out and roll it over by hand a few times to make sure everything is clear before hooking it up to a PTO - parts get broke real fast that way. Watch a couple You Tube videos on repairs and operation and you'll gain an understanding of how everything is supposed to work. And you'll need the manual if one wasn't included. The 315 is a really good baler with a fairly high capacity especially compared to the 14T and others you were looking at. The wider pickup makes operation a lot easier too. The Ford will pull it no problem. It doesn't appear to have a hitch so you won't be pulling wagons behind it. It basically looks like a newer version of my 276 with a bigger twine box. I pull mine with a Farmall 350 (about 38hp) or a Allis D17 (about 60hp) - neither has any issue handling it - you'll slug it and have the PTO clutch slipping before you run out of power.
Those balers were built to make several thousand bales a year and came onto the scene just as big round balers started taking over the market. Good chance you have a low use model. Most of the balers that were produced in the mid 1970s and earlier saw a lot of hard use and were basically worn out by the time the big round balers took over.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.