Tractor Talk Discussion Board |
Re: Need tips for front end loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Canadian Cowboy on December 31, 2001 at 21:00:48 from (209.53.125.146):
In Reply to: Need tips for front end loader posted by Evan on December 31, 2001 at 19:45:15:
Just a guess but sounds to me like your troubles are with you hands on the loader controls. You wanna have the bucket level with the ground to start off, come up the pile, lower the lower to the ground (till it touches, not digs in) You wanna drive the tractor into the pile a little ways while curling up the bucket. once full lift loader and drive backout. when you get the hang of it you can curl the bucket and lift the loader at the same time plus put tractor into reverse in matter of sec... With weight and 4wd you should have no troubles getting a full bucket, its all in how you load it (the bucket) Pratice! Happy new year :-)
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|