Posted by kcm.MN on September 07, 2019 at 22:45:27 from (174.219.139.230):
In Reply to: math posted by ohiojim on September 07, 2019 at 13:21:14:
Quoting Removed, click Modern View to see
If the tank was full, that would be a true statement. Using just rough calculations, compare these two drawings:
1. 38"d x 60"l -- means that the tank is roughly 40% full:
15/38=0.3947%
2. 38"d x 60"h -- means that the tank is roughly 25% full:
15/60=0.25%
There are several variables that were not included with the OP:
1. Is the tank vertical or horizontal? I asked that question because a LOT of times I see items for sale with measurements that are given incorrectly; ie., it may be listed as l (length) when it should be listed as h (height).
2. Is the tank actually round, or is 38" simply the circumference? Again, I see that mistake made often.
3. Are the ends flat, or are they convex?
4. Are the measurements internal or external? If external, what's the wall thickness? Is the wall thickness even on all sides?
5. Are there any bladders or other items inside the tank that take up space, such as with a water well's pressure tank? This being a fuel tank, there are likely not any bladders inside. BUT, I don't know if ALL fuel tanks would be bladder-free.
6. How precisely was the remaining fuel/liquid measured? If off by even 1/8", that would affect the final measurement....depending on how precise of a measurement you wish to have.
Along with that last thought, was the tank perfectly level when measured?
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
