Posted by baydog1 on September 10, 2019 at 18:22:29 from (174.226.4.3):
Hello everyone. I have a 801 Powermaster that is about plane as it gets. The problem I'm having is I have a Mower or bush hog or brush cutter hooked to it and can't keep it level. Got my lift arms hooked up and level my deck with the tractor running using the lift arm controller... I then adjust the lift arm controller stopper to the height I'm looking for and tighten it up. Then I adjust my center link to fit at my adjusted height. The problem I'm having is once I lift the cutter up and let it down to the controller stop it doesn't really move... I have to go past the stopper and then of course the mower scalps and then I have to yank up on the lift arm controller and then push back down on it until it levels out and most of the time during all the up and down and all around the the controller ends up on the stopper but there sure is a lot of scalping and uneven grass before I can get to the sweet spot which is where I set the mower to cut at... When I do have any implement in the full up position it does hiccup a bit. Is this as good as it gets because it's a really old tractor or is there any way I can improve this hair pulling situation. Thanks for your time and help
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
