I agree with Mark's post. To add to it a bit (OK, a lot), it has been my belief that homes with conventional water softeners should have 2 separate waste water drains; one for sewage and the other for grey water, which "could" go directly onto the lawn, or could go to a grey water drainage pit. That way you have less problems all around. However, that is the more expensive option as well.
According to the OP, there is one more thing I would want to do. Given that salty brine has been drained into the basement for that many years, I would try to find an inspector that specializes in testing the quality of your concrete floor. It's "possible" that salt may have weakened the floor a bit -- not a problem if it's just resting on earth/gravel and no open spaces, but could possibly present a problem if covering a non-reinforced area. It helps that your water table has not historically backflowed into the basement, but that doesn't mean the water table didn't get close enough for salt solution to come into contact with the concrete.
Lots to think about, but the choice is ultimately yours. Depending on the amount of headroom in the basement and whether or not it's even used for anything else, it might even be less costly to simply do what work needs to be done down there, then have another 3" or 4" of concrete poured over the original floor.
As for a pump that can get the brine up and out of the basement, another possibility would be to use a venturi to move the brine. Would add some amount to the water bill, but for this you could even use from a rain water catchment, if you wanted. If there is any way to move the softener to a higher position, that would make ejecting the brine solution all the easier.
Lastly, there's another type of softener system I heard about years ago but have NO experience with. Rather than using large amounts of salt, it uses smaller amounts of peroxide. Mixing the peroxide with water would render any ejection water safe for pumps, concrete, yard & plants, etc. It would simply be grey water.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
