Posted by Leroy on September 19, 2019 at 18:47:08 from (96.45.243.241):
In Reply to: jd1020 posted by randy1 on September 19, 2019 at 14:07:37:
I have to ask the model. Is it the LU, the RU or the HU?The HU on 36" rear rubber will have more traction than a RU on 28" rubber and I think the LU has only 24" rubber on the back and if you load the rear tires that 36" tire will have a lot more weight on it for traction than the smaller 28" tire, And with the bale on front I think you are going ro need all the rear weight you can get especially if ground is going to be slipery, may even need chains. When I was still farming I would have liked to have had a HU. But no 2020 or larger, to me the Ford 4100 was twice the tractor the 2020HU was. I owned the Ford and drove the Deere at work. And I drove my uncles 3020 and you could not give me that thing to use. But the way those 3020's seem to be selling for that 1020 if a HU is not over priced.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
