You can easily bore under the drive way with a water powered boring tool. They cost from a hundred to several hundred.. There are several types. One I have used works with a pressure washer. You dig a hole 8 foot long and narrow other than right at the driveway. You taper the bottom away form the drive way. Drop a sump pump in that end. The tool is just a nozzle that sprays water out the front in a pretty straight pattern. It also had opening that spray out the back. Take a piece of conduit and slip the nozzle with the hose, to the end of the conduit. Hold the conduit against the dirt wall under the drive way. Push the conduit while holding the nozzle at the end of the conduit. The front spray pattern will melt the dirt and the rear facing ones will push the dirt and water back the conduit. You can slowly advance the conduit. Just keep adding sections of conduit until you have crossed whatever you going under.
They also make them that you used just a garden hose and a drill. Borit is a common name of one of these tools.
https://www.borit.com/
Talk to some local plumbers. One of them may have the tool and rent it to you.
Here is video of a fellow just using a common brass garden hose nozzle to bore under a side walk.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
