Tractor Talk Discussion Board |
Re: 3pt won't stay up. Do I have a bad seal or bad cyl
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big time on January 10, 2002 at 23:29:38 from (216.109.205.111):
In Reply to: 3pt won't stay up. Do I have a bad seal or bad cyl posted by Eric Joseph Patterson on January 10, 2002 at 20:22:10:
raise and block 3 point. pull return line off cyl. cap return line. remove supply line. cap supply line. remove blocks if it drops a bit from air its ok, but if it leaks down its the cylinder. Our 460 needed the Valve body rebuilt, was all common hydraulic parts, nothing exotic, any hydraulic supply should have the orings and stuff. hope your valve body isnt scored. we couldnt find one 15 yrs ago.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|