Posted by LAA on October 11, 2019 at 20:36:22 from (130.117.142.131):
In Reply to: Tub grinders posted by Al Baker(pumpman) on October 11, 2019 at 10:26:43:
I have a haybuster and as JD Seller mentioned I also have a TMR wagon, I don't grind in piles because in our climate (rain all winter) I would lose way more than I save if I did. I feed a lot of cull cows as well as maintain a cow herd, ground hay is easier for short mouth and zero mouth cows to eat and they eat more of it therby gaining much faster. Mixing liquid feed and rolled corn or grain screening pellets in the TMR makes a complete ration that does not get sorted in the bunk, for cows on pasture we use liquid feed and water to bind the hay, also, any poor hay is eaten and not sorted this way. If labor is tight then the down side is daily feeding or feeding at least every other day for cows on pasture, best to have covered bunks especially if feeding every other day, I always keep a few rolls in rings or feeder wagon in case it gets too muddy or raining steady for a few days in the winter. As far as payback, you can buy a good used tub grinder reasonable, they will be higher this time of year and get cheaper in the spring, same with used TMR wagon, this type of equipment is meant to grind/mix thousands of cycles and maintenance is cheap. I know that my current set up saves 20% on avarage on feed costs and actual hay saved, it paid off quickly.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.