Posted by Bruce(OR) on October 19, 2019 at 11:48:11 from (65.102.27.176):
In Reply to: Oil Change posted by John in La on October 19, 2019 at 11:24:38:
Two reasons. I used to work at a few of those quicky oil change places. One place our oil filters cost about $.79 cents each. Name brand with held to protect the guilty. Another time I was also feeling lazy and took my gasser truck into a quicky oil change place, I asked for 15/40 oil into it and the lube guy brought up oil jugs from down stairs with the seals already broken. If I do go to one of those, I am happy they got the drain plug tight and oil put in. That air filter you had replaced will probably be disgusting dirty in about 6 months, without a dirt road. Up-sales of inferior parts is the key to a profit margin. The mom and pop shop might desire your oil change to keep their doors open and might be a bit more flexible when your vehicle needs actual repair. They might also be inclined to use a better quality part. Not always, but possible. Quicky oil changes as a good rule, do not use quality parts.
"Meets OEM standards" Or "Exceeds OEM standards"? OEM being murky at best, See Chinese.
That 7 quart oil might set me back $21 and probably $12 for the same quality filters. $33 or $64? Think I can do it myself most days for $30. Or get a better quality filter and still save $20 and get the drain plug straight, not over-tightened or loosey-goosey.
I have seen most of the help and it's a judgment call.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
