Posted by The tractor vet on November 01, 2019 at 19:15:38 from (104.179.81.68):
In Reply to: Carb Float Repair posted by RCP on November 01, 2019 at 18:16:40:
repairing a float is a lost art , vary few of us old guys can do this . I am one of them . The big this is ya don't use epoxy and the weight of the float must be maintained . to drain ya look for th tiny air hole that is already there with a small amount of solder and you open that hole and drain thru that . Then ya wash it out REAL GOOD and let it dry . Then with and old style soldering iron and flux ya resweat it and allow to cool then ya put a tiny drop of solder on the air hole and seal that last. If not done correctly when it cools it will suck the side in and now ya have JUNK. The problem you will run into is getting the acid core solder and the flux as plain old acid core will not do it all on it's own. and like said before the weight must stay the same so you have to weigh vbefore after it is drained and dry and weigh when done , so ya need a FLOAT SCALE
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Time Threshing - by Anthony West. A lovely harvest evening late September 1947, I was a school boy, like all school boys I loved harvest time. The golden corn ripens well and early, the stoking, stacking,.... the drawing in with the tractors and trailers and a few buck rakes thrown in, and possibly a heavy horse. It would be a great day for the collies and the terrier dogs, rats and mice would be at the bottom of the stacks so the dogs, would have a busy time hunting and killing, all the corn was gathered and ricked in what we c
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
