Tractor Talk Discussion Board |
Re: JD D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on January 17, 2002 at 20:24:52 from (65.89.19.178):
In Reply to: JD D posted by IaGuy on January 17, 2002 at 18:05:24:
D's were short for sure, but there's a lot of "ballast" in a small area in those old boys. I've noticed at tractor pulls, most D's do get their front end up pretty early, I'll admit. If you can find a cutaway or cross-section picture of an old D, you'll see they angled the drawbar down some to make the line of draft kinda straight from the center of pull in the plow to the center of the rear axle. I never drove one much except pulling a 10 foot McCormick Deering Grain Binder, there I noticed they can give you quite a thrill crossing dead furrows and other undulations with the seat so far behind the rear axle and that short wheelbase.
Follow Ups:
Home
| Forums
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|