|
Tractor Talk Discussion Board |
Re: Re: Patching up a Kohler cylinder head
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by butch in kansas on January 18, 2002 at 19:05:41 from (63.167.133.110):
In Reply to: Re: Patching up a Kohler cylinder head posted by george on January 16, 2002 at 14:30:05:
thats simple use a good grade of tapping fluid find a 18mm tapping kit install right size insert make sure its clean and use thread sealer supplied find the 18mm to 14mm bushing insert and your business again 18mm are getting hard to fine for oldd tractor so an adapter has been made to take them 14mm any good farm and auto parts house should have what you need when you weld allum its gets hard and with the fins that close the heat will travel fast and could warp then you will buy that new heado
Follow Ups:
Home
| Forums
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
