|
Tractor Talk Discussion Board |
Re: Gear Ratio Math?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on January 19, 2002 at 13:55:51 from (209.47.89.119):
In Reply to: Gear Ratio Math? posted by K-Mo on January 19, 2002 at 06:06:48:
I guess there are 10 different ways of looking at this. I used a percent change from one gear in a pair to the next gear in that pair. Does this following explanation make any sense? STANDARD: The 22:14 ratio gives you a 157% gearing "up" change (since 22 is 157% greater than 14). Now some guys will argue with this math, but taking 157% as 1.57 as a decimal, then 14 X 1.57 = 22 (approximately). This is followed by a 14:47 or 336% negative change for the next pair of gears which are gearing "down" (since 47 is 336% greater than 14). Net result is a 179% (336-157) gearing down change from start to finish for this set of 3 gears. HIGH: The 20:16 ratio gives you a 125% gearing up (higher) for the first set, followed by a 16:45 or 280% gearing down (lower) for the next set of gears. Net result is a 155% gearing down change from start to finish for this set of 3 gears. So, the standard gear set overall gears the tractor down 179% while the high gear set overall gears the tractor down only 155%. Thus, the high gear set gears down the tractor less (or is gearing it higher) and the tractor will travel faster while in the high range. Boy, hope I'm right on this after all that.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
