Long spear works well for dropping bales into feeders, also can stab into the side of a bale if required.
You do need to stab the bale pretty close to center so it does not spin when you lift it.
Double spikes or like what you call the pallet fork style I find to be a little faster to use when loading bales off the field.
One of my tractors I have set up with the doubles on front and back.
By picking from the bottom it allows me to reach high enough to load a top row on my bale truck from the side.
If trying to move cruddy old bales they will often fall apart when picked with a single spike, cradling from the bottom even if the strings are gone still usually works.
On a small tractor I prefer the fork style front and back.
On mine it does not matter how heavy the bales are, as long as I pick one with the rear first it gives me enough weight on back to counter the weight of the one on the front.
I did build an upright guard for mine so a bale can not come off backwards and end up on my hood or head.
If built heavy enough they also work well for pushing yourself out of ruts, mud, snow etc.
Come time to slaughter an animal one chain to each side does the trick.
If you park inside and are short on space the forks easily fit under the vehicle in front of it and dropping the rear forks down to the floor saves your shins.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
