Posted by keith True on November 18, 2019 at 05:33:08 from (73.68.29.112):
In Reply to: Re: Hitting deer posted by Stephen Newell on November 17, 2019 at 18:53:36:
i never hit a deer that I saw first.It was always a blur and a crash.I was in a Mack one morning,about 3 AM and had a big thump.lost my right headlight and some debri came up over the hood and into the windshield.I pulled over and found the whole front lower quarter of my nose missing,headlight bucket and all.A state trooper pulled up and took a look,we figured out I had hit a deer.We walked back to where I had hit it,he had the idea to put it out of it's misery if it was still alive.It jumped up in front of us and ran off,so it must have been stunned.The guy I was working for had spent a lot of time hauling out of western Pennsylvania and every truck he owned had the front bumpers trimmed off just a couple of inches outside of the frames.He had been through the experience of deer bending the bumper ends into the steering tires more than once.The trucks he bought later had rubber bumpers from the frame out.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
